From Earlham CS Department
Jump to navigation
Jump to search
|
|
| (2 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| − | proto.cs.earlham.edu is an ntp timeserver for Earlham's network. The time value it outputs come from some weighted average of two inputs. The first input is a NIST server located in Chicago. The second input is a GPS device on the fourth floor of dennis (in a box connected to the 4th floor lab's closet).
| |
| | | | |
| − | '''Setup Procedure (Serverside)'''
| |
| − | Plug the GPS device into proto via USB.
| |
| − | Make a symbolic link from the presence of the USB device on proto to /dev/gps0.
| |
| − | Use the configuration file in the footer of this page or edit your configuration file to contain many of its ideas.
| |
| − | Restart the ntp daemon.
| |
| − |
| |
| − | '''Setup Procedure (Clientside)'''
| |
| − | Insert this line into your ntp.conf: "server 159.28.230.6"
| |
| − |
| |
| − | '''Debugging'''
| |
| − |
| |
| − |
| |
| − | '''Explanation of Choices'''
| |
| − | Since it is easy to configure one's time to a NIST timeserver and NIST uses highly accurate atomic clocks, you might wonder why we bother with the GPS. The locality of the GPS elimintates network latency and network jitter as sources of error. While, for Earlham, the GPS signal may be more accurate, it is also less reliable. Somebody might accidentally unplug the GPS and HIP might not notice for a few hours/days, whereas the NIST server's importance means that attentive, skillful people would notice problems sooner. Considering this worst case scenario, and the fact that the different between 3:17:30 and 3:17:20 100% of the time is less important to most people than the difference between 4:17:30 and 3:17:30 0.28 percent of the time, it is best to mix the inputs.
| |
| − |
| |
| − | [[File:ntp.conf]]
| |
Latest revision as of 13:21, 8 November 2013
