https://wiki.cs.earlham.edu/index.php?action=history&feed=atom&title=HIP%3AYSI-600R%3Aminicom 2026-07-16T02:24:34Z Revision history for this page on the wiki MediaWiki 1.44.2 https://wiki.cs.earlham.edu/index.php?title=HIP:YSI-600R:minicom&diff=5818&oldid=prev 2007-06-29T15:47:05Z

<p></p> <p><b>New page</b></p><div>= Setting-up minicom =<br /> The following minicom screen shows the correct configuration to use with a YSI sonde on comm 2 of the TS-7260 board.<br /> ------------------------------------------------------------------------<br /> | A - Serial Device : /dev/ttyAM1 |<br /> | B - Lockfile Location : /var/lock |<br /> | C - Callin Program : |<br /> | D - Callout Program : |<br /> | E - Bps/Par/Bits : 9600 8N1 |<br /> | F - Hardware Flow Control : No |<br /> | G - Software Flow Control : No |<br /> | |<br /> | Change which setting? |<br /> ------------------------------------------------------------------------<br /> = Using minicom with Sonde =<br /> * Enabling VT100 emulation in the sonde will make it clearer to use the menu. To do this, set Main &gt; Advanced &gt; Advanced setup &gt; VT100 emulation.<br /> * Many of the sonde commands and menus available via RS-232 are documented in the [http://www.cs.earlham.edu/~hip/ysi_6series_manual.pdf YSI sonde manual]. However, there are some that are worth noting here.<br /> * Typing &quot;run&quot; at the sonde prompt will cause the sonde to print data lines after a pause of a few seconds. The printing of lines continues until a &quot;0&quot; is sent to the sonde. The &quot;0&quot; will cause the sonde to immedaitly stop printing at a new line without echoing the &quot;0&quot;. Which data values are printed can be set in the sonde menu Main &gt; Report.</div>

Klyceje